Ver. 3.0 - Panasonic UF-9000 Service Manual

For all previous DP-180/190, and UF-9000 with Serial No. prefix
Control Panel) use the following firmware:
< Firmware Code File: UF-9000_AU_xxxxxxxx.exe or DP-190_180_AU_xxxxxxxx.exe >
UF-9000
SC
DP-180/190
SPC
Slot 1 FROM PCB
Main Unit Firmware Code Updating Instructions
8.1.1. Updating through a LAN Port (The Quickest, and Most Easiest Method)
The firmware code can be easily updated when the main unit is connected to a LAN.
The Network Firmware Update Tool can also be used by connecting to the machine using a crossover
cable, if the unit is not connected to a LAN.
1) Install the Network Firmware Update Tool to your PC
The option CD-ROM includes the Network Firmware Update Tool, and the Main Unit Firmware Code.
Please refer to the following Operating Instructions to install the Network Firmware Update Tool.
The installation password is "workio".
Operating Instructions:
\xFirmware\Tools\NwFirmup\NwFirmup OI.pdf (Refer to the
Setup:
\xFirmware\Tools\NwFirmup\Setup\Setup.exe
2) Preparing the Firmware Code
Double click the appropriate Destination Shortcut Batch File, and copy the Firmware Code File on the
CD-ROM to the Firmware Data Folder in your PC. Note that the files in the Archive will be extracted
automatically into the designated folder when the Archived file (.exe) is Double-clicked.
Example:
From:
Destination Shortcut Batch File: D:(CD-ROM Drive) \ xFirmware \ USA.bat
[Navy Blue Control
Firmware Code File: UF-9000_AUR_xxxxxxxx.exe or DP-190_180_AUR_xxxxxxxx.exe
[Light Blue Control
Firmware Code File:
To:
Firmware Data Folder:
3) Preparing the Main Unit for the Firmware Upgrade
Make sure the unit's Key Operator Password is the same as the tool's password.
Make sure the unit is in an idle state (e.g. not making copies, not printing, etc.).
4) Upgrading the Main Unit's Firmware Code
Start the Network Firmware Update Tool, and select the following Firmware Code Folders in the
C:\Panasonic\Panasonic-FUP\Data folder, and then follow the display instructions to upgrade the
Main Unit's Firmware Codes.

Ver. 3.0

Standard Firmware
(SC = Type A)
DX-TriAxVxxxxx_xx
DP-TriAxVxxxxx_xx
DX-TRI-SAxVxxxxx
Not Required
Panel]
Panel]
UF-9000_AU_xxxxxxxx.exe or DP-190_180_AU_xxxxxxxx.exe
C:\ Panasonic \ Panasonic-FUP \ Data
BF [February
PCL Firmware
(SC = Type B)
DX-TriBxVxxxxx_xx
DP-TriBxVxxxxx_xx
←
Required
NW Firmware Update Tool OI
265
UF-9000
DP180/190
2006] and below (Light Blue
PostScript Firmware
(SC = Type D)
DX-TriDxVxxxxx_xx
DP-TriDxVxxxxx_xx
←
Required
on the CD)
APR 2006