Table Intro-1. Auto-Configuration Settings For Code Rotary Switch Set To "1" - Panasonic DBS 576 Technical Manual

Section 400 programming

Hide thumbs Also See for DBS 576:

Table of Contents

Introduction to DBS 576 Programming

10. After the Auto-Configuration process is complete, change the CODE rotary

Introduction

Table Intro-1. Auto-Configuration settings for CODE Rotary Switch set to "1"

Configuration

FF-/Soft Keys

FF-Key Assignments: On the auto-configured extensions, FF1=CO#1; FF2=CO#2; ... FF32=CO#32.

Ringing: On Extensions 100 and 101, COs#1 thru #32 will ring the extension for incoming calls.

EXT Assignments: Can be either AEC or DEC cards. The system will automatically detect these cards when they

are installed.

Built-In VM (in Pattern 2): VPU Ports 1-4 are assigned Extension Nos. 600-603, and included in Hunt Group #1.

Hunting method is Pilot Distributed. However, the Hunt Group' s pilot number is not assigned.

Built-In VM (in Pattern 5): VPU Ports 1-8 are assigned Extension Nos. 600-607, and included in Hunt Group #1.

Hunting method is Pilot Distributed. However, the Hunt Group' s pilot number is not assigned.

Patterns 1-3: (all countries except USA) Intended for CAB-40.

USA only: If Pattern 2 is used, be sure to change the FS-5 card assignment (VSSC Card always goes in FS-11).

Applications

Page Intro-8

switch back to "2" (to avoid accidental memory erasure in the future).

VPU Ext.600-603,

in Hunt Group 1

DBS 576 (USA) issued January 1999

-- Free Slots --

Section 400: Programming