Cutting Wheels - DeWalt D28106 Instruction Manual

Cutting Wheels

Type 1 guard
backing flange backing flange
abrasive cutting wheel diamond cutting wheel
clamp nut
the off position as described above after any interruption in power supply to the tool, such
as the activation of a ground fault interrupter, throwing of a circuit breaker, accidental
unplugging, or power failure. If the switch is locked on when the power is connected, the
tool will start unexpectedly.
To start the tool, slide the ON/OFF switch (L)
toward the front of the tool. To stop the tool,
release the ON/OFF switch.
For continuous operation, slide the switch
toward the front of the tool and press the for-
ward part of the switch inward. To stop the
tool while operating in continuous mode,
press the rear part of the switch and release.
Sanding Discs
rubber backing pad
Type 1 guard
sanding disc
threaded clamp nut
clamp nut
L
Type 27 guard
hubbed sanding flap
disc
LOCK-ON BUTTON (D28402)
The lock-on button (J) offers increased comfort in extended use applications. To lock
the tool on, push the lock-off lever (B) toward the back of the tool then depress the
paddle switch (A). With the tool running, depress
the lock-on button (J). The tool will continue to
run after the paddle switch is released. To
unlock the tool, depress and release the paddle
switch. This will cause the tool to stop.
CAUTION: Allow the tool to reach full speed
before touching tool to the work surface. Lift the
tool from the work surface before turning the
tool off.
7
Sanding Flap Discs
Type 27 guard
backing flange
non-hubbed sanding flap
disc
threaded clamp nut
J
A B