Burner - Miele CS 1028 Operating And Installation Instructions

Burner

Do not clean any parts of the burner
in a dishwasher.
The burner should be dismantled and
then cleaned by hand using a solution
of warm water and a little washing-up
liquid applied with a soft sponge.
Parts of the burner that cannot be
removed should be wiped clean with a
damp cloth only.
The ignitor and ignition safety device
should be very carefully wiped clean
using a well wrung out cloth.
Do not let the ignitor get wet. If it gets
wet it will not spark.
After cleaning dry all surfaces with a
clean cloth.
Make sure that the flame slits are clean
and completely dry.
The surfaces of the two burner caps
will become more matt with time. This
is quite normal and will not affect the
operation of the hob.
Cleaning and care
To reassemble the burner
After cleaning the burner, it must be
reassembled in the correct order.
^ Place cover plate c over burner
base d so that the the ignitor and the
ignition safety device extend through
their respective holes in the cover
plate. The cover plate must sit evenly
over the burner base.
Do not use a warped cover plate!
^ Place the burner head in position
above the cover plate making sure
that pins e slot into their respective
holes in the burner head.
^ Then place burner cap a in position.
27