MZ-RH910
• This set can be disassembled in the order shown below.
3-1. DISASSEMBLY FLOW
Note 1: The process described in
Note 2: Without completing the process described in
SET
3-2. CASE (LOWER) BLOCK
(Page 6)
3-3. MAIN BOARD
(Page 7)
3-5. MECHANISM DECK (MT-MZNH900-181J)
(Page 8)
3-7. GEAR (BSA), GEAR (SB)
(Page 9)
3-8. OP SERVICE ASSY
(Page 9)
3-9. DC MOTOR SSM18D/C-NP (SPINDLE) (M701),
DC MOTOR (SLED) (M702),
DC MOTOR UNIT (OVER WRITE HEAD UP/DOWN) (M703)
(Page 10)
Note: Follow the disassembly procedure in the numerical order given.
3-2. CASE (LOWER) BLOCK
S895
knob (hold)
7 screw (M1.4)
6 Slide the knob (Open)
in the direction of arrow.
8 case (lower)
block
6
SECTION 3
DISASSEMBLY
can be performed in any order.
, the next process can not be performed.
3-4. PANEL (UPPER) BLOCK
(Page 7)
3-6. BATTERY CASE BLOCK
(Page 8)
3 screw (M1.4)
2 battery lid assy
3-10. HOLDER ASSY
(Page 10)
5 two screws (M1.4)
4 screw (M1.4)
1 Open the battery lid
assy in the direction
of arrow.