D-Link DFE-690TXD Installation Manual page 5

Insert the DFE-690TXD into your Laptop
This section refers to all users, regardless of
which operating system you use.
You must first install the drivers as explained in Section 1 (for Windows
users), or Section2 (for Macintosh users). If you have not done this and
you have inserted the DFE-690TXD into the Cardbus slot, you will need
to cancel the New Hardware Wizard (for Windows users), and start over
at the beginning of this installation guide (for Windows or Macintosh).
Insert the DFE-690TXD into the Cardbus slot of your laptop.
Gently insert the front end of the DFE-690TXD into the Cardbus slot on
your laptop until it is firmly seated. Make sure that the card is face-up, as
shown. Do not force the insertion.
Connect an Ethernet Cable (CAT5) from a switch or hub to the DFE-
690TXD.
Windows users: Continue to Section 4.
Macintosh users: Continue to Section 5.
PC Card Slot
-5-