Figure 76 - Configuring Qos By Using The Web Interface (Rule2); Figure 77 - Configuring Qos By Using The Web Interface (Vap Qos Parameters) - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide
•) Wild Card Mask: 0.0.0.255
•) Source Port: Select the option
•) Select From List (Source Port): www
7.) Click Apply to save the rule.
8.) Select New Rule from the Rule menu and create another rule with the following settings:
•) Action: Permit
•) Match Every: Clear the option
•) Protocol: IP
•) Address: 192.168.1.23
•) Wild Card Mask: 0.0.0.0
9.) Click Apply to save the rule.
10.) Navigate to the Client QoS > VAP QoS Parameters page.
11.) For the Client QoS Global Admin Mode option, select Enabled.
12.) From the VAP menu, select VAP 2.
13.) Select the Enabled option for Client QoS Mode.
14.) From the ACL Type Up menu, select IPv4.
15.) From the ACL Name Up menu, select acl1in.
16.) Click Apply to update the AP with the QoS settings.
DiffServ Configuration
January 2015

Figure 76 - Configuring QoS by Using the Web Interface (Rule2)

Figure 77 - Configuring QoS by Using the Web Interface (VAP QoS Parameters)

Appendix B - Configuration Examples
Unified Access Point Administrator's Guide
Page 122