Installing A Micro Sd Card - Motorola VC70N0 Product Reference Manual

2 - 10 VC70 Vehicle Computer Product Reference Guide
PSU Installation Template
Figure 2-6

Installing a Micro SD Card

A micro SD (Secure Digital) card provides secondary non-volatile storage. The card holder is located on the right
side of the VC70 under the Service door.
To install the micro SD card:
Remove the two T8 TORX screws securing the Service door.
1.
Service Door
Micro SD Card
Install Memory Card
Figure 2-7
Push the memory card, with the contacts up, into the card slot until it locks.
2.
Replace the Service door and secure using two T8 TORX screws.
3.
CAUTION Ensure to torque the screws to seal the device properly. Otherwise, sealing can be compromised.
Torque the Torx head screws to 4.0 + 10% kgf-cm (3.5 ± 10% lbs-in).
Measurements are given in
millimeters.
Memory Card
Slot