Document Revision 1A
___________________________________________________________________________________
2.3
2.4
___________________________________________________________________________________
1 - 6
Connectors
The following connectors are used:
J1 Ethernet Connector
H
This connector is a single 10/100 MPS Ethernet Connector. This port
has Auto-Medium Dependent Interface Crossover (MDIX) to allow using
either a straight-through Ethernet cable for connection to a PC or a
crossover Ethernet cable.
The Ethernet Interface setting allows manual configuration of the
Ethernet port from the Web Interface, and can be set to operate in the
following port speed and duplex mode combinations: 10MB/Full Duplex,
10MB/HalfDuplex,100MB/Half Duplex, or 100MB/Full Duplex, Auto-
Negotiate.
J2 Serial Connector
H
This 10-pin serial terminal is used for debugging operations only.
H
J4 Compact Flash
Reserved for Future Use.
Environmental Conditions
The following environmental conditions apply for the CNF module operation:
Operating Temperature:
Operating Humidity:
°
°
°
+32
to 104
F (0
to 40
10% to 90% (non-condensing)
Electra Elite IPK II
°
C)
CNF(16)-U20 ETU