Section 3: Commands And Syntax; Using The Get Command - D-Link DWL-8600Ap Reference Manual

D-Link Unified Access Point CLI Reference Manual
Sec ti o n 3: Co mma nd s an d Sy nta x
The CLI for the UAP provides the following commands for manipulating objects:
• get
• set
• add
• remove
Caution! Settings updated from the CLI (with get, set, add, remove commands) will not be saved to the startup
configuration unless you explicitly save them via the save-running command. For a description of configurations
maintained on the AP and details on how to save your updates, see
U
SING THE GET
The "get" command allows you to get the property values of existing instances of a class. Classes can be "named" or
"unnamed." The command syntax is:
get unnamed-class [ property ... | detail ]
get named-class [ instance | all [ property ... | name | detail ] ]
The rest of the command line is optional. If provided, it is either a list of one or more properties, or the keyword detail.
The following example uses the "get" command on an unnamed class with a single instance:
get log
There is only one log on the AP, so the command returns information on the log file.
The following example uses the "get" command on an unnamed class with multiple instances:
get log-entry
There are multiple log entries but they are not named, so this command returns all log entries.
The following example uses the "get" command on a named class with multiple instances:
There are multiple BSSes and they are named, so this command returns information on the
The following example uses the "get" command on a named class to get all instances:
get mac-acl all mac
get mac-acl all
Note: wlan0bssvap0 is the name of the basic service set (BSS) on the wlan0 interface. For information on
interfaces, see "Interface Naming Conventions" on page
© 2001- 2009 D-Link Corporation. All Rights Reserved
6
C
OMMAND
"Saving Configuration Changes" on page
get bss wlan0bssvap0
11.
BSS named "wlan0bssvap0."
12.