3.11
Connection to the FD 300 Diskette Drive
FD 300
Figure 17 Connection to the FD 300
With this diskette drive it is also possible to work with 5
P610.
The FD 300 is connected with the provided cable. The end of the cable marked
"System" is plugged into the P610. The Centronics port is used on the P610 for
this purpose (see Figure 8).
The following sequence must be observed in order that the FD 300 be correctly
addressed:
Step 1
Switch off P610
Step 2
Connect FD 300
Step 3
Set "PRT/B/A" switch to "B"
Step 4
Switch on FD 300
Step 5
Switch on P610
Note The drive code of the FD 300 is standardly B:.
28
Programming Preparation
P610
1
/
" diskettes on the
4
22