Before The First Use; First Pre-Cleaning; Operation Of Cooking Surface; Touch Control Sensor Controls - Electrolux 599 50 74 38 Service Manual

Before the First Use

First Pre-Cleaning

Wipe the ceramic-glass cooking surface with a wet cloth to remove possible traces of production.
Attention: Do not use any sharp and scouring detergents! The surface could be damaged.

Operation of Cooking Surface

Switching on the cooking zone may cause a short humming. This is a peculiarity of all ceramic-
glass cooking zones and does not impact the function or lifetime of the appliance.
TOUCH-CONTROL Sensor Controls
To operate the TOUCH-CONTROL sensor controls put your finger from above and flat on the desired
zone until the corresponding display lights up or goes out and/or the desired function will be carried out.

Switching on the Appliance

The complete appliance will be switched on by the sensor control "on/off"
Touch the sensor control "on/off" for approximately one second. The digital display shows n
the digital point flashes.
After the sensor control "on/off" was activated to switch on your appliance it is necessary to select
one of the cooking zones within approximately 10 seconds by the cooking zone selection keys.
Otherwise the appliance will switch off again for safety reasons.

Switching off the Appliance

To switch off the appliance completly actuate the sensor control "on/off"
Touch the sensor control "on/off" for approximately one second.
After switching off a single cooking zone or the complete cooking surface a possibly still existing
residual heat will be indicated with
zones.

Selection of Cooking Zones

To select the desired cooking zone
Touch the associated sensor control for approximately one second.
In the associated indication of the cooking zone a zero with a digital point lights n.
TSE-N 01.00 A. B.
(like "hot") in the digital displays of the corresponding cooking
- 9 -
.
.
599 50 74 38 EN
and