Connecting The Multiple Units With The Lan - Sony BKM-16R Operation Manual

1
Turn off the MAIN POWER switch of the monitor
before connecting the units.
2
Set the NETWORK switch of the monitor and the unit
to PEER TO PEER.
3
Connect the LAN (10/100) connector of the monitor
and the LAN (10/100) connector of the unit by using
the SMF-700 or the cable supplied with the controller
attachment stand such as BKM-37H, or a 10BASE-T/
100BASE-TX straight LAN cable (shielded-type,
optional).
Note
When an optional LAN cable is connected, use a
shielded-type cable to prevent a malfunction due to
noises.
4
Connect the DC 5V OUT connector of the monitor and
the DC 5V/12V IN connector of the unit by using the
SMF-700 or the cable supplied with the controller
attachment stand such as BKM-37H.
Or connect the output cable of the AC adaptor supplied
with the unit to the DC 5V/12V IN connector of the
unit.
Connecting the Multiple Units with
the LAN
The unit controls up to 32 monitors. Up to four units are
connected to one monitor in single mode.
Note
The unit cannot control monitors in another subnetwork.
NETWORK switch
tSet to LAN.
Monitor
LAN (10/100)
connector
AC adaptor (supplied
with this unit)
Switching hub
(recommended: with
AUTO MDI/MDI-X
function)
DC 5V/12V IN
connector
BKM-16R
(this unit)
NETWORK switch
tSet to LAN.
1
Turn off the MAIN POWER switch of the monitor
before connecting the units.
2
Connect to the network by using a 10BASE-T/
100BASE-TX cable (shielded-type, optional).
Notes
• When an optional LAN cable is connected, use a
shielded-type cable to prevent a malfunction due to
noises.
• We recommend to use an optional switching hub
with auto selection function (AUTO MDI/MDI-X)
of a straight/cross cable.
When the switching hub without auto selection
function is used, connect the monitor and switching
hub with the straight cable, and the unit and
switching hub with the cross cable.
Monitor
LAN (10/100)
connector
LAN (10/100)
connector
Connections
13