Using OmniBook Plug-In Modules
The plug-in module bay can hold a DVD / floppy disk drive, a CD-ROM / floppy disk
drive, an LS-120 drive, a second battery, or a second hard disk drive. This
documentation describes the module that shipped with the OmniBook—the DVD /
floppy disk drive or the CD-ROM / floppy disk drive. If you've purchased other
accessory modules, refer to the accessory documentation that accompanied them
for instructions.
This section describes how to
♦
Install hot-swap support.
♦
Replace a plug-in module.
♦
Insert or eject a floppy disk.
♦
Insert or remove a DVD or a CD.
To install hot-swap support
The Agaté Tioman "hot-swap" software for Windows 95 and Windows 98 is loaded
on the hard disk, but it is not installed. If you install this software, you can switch
most modules in the plug-in bay without shutting down the computer and rebooting.
(This software does not support Windows NT.)
• Click Start, Programs, Agaté Tioman for HP, Setup, then follow the onscreen
instructions.
Making Connections
Using OmniBook Plug-In Modules
4-3