Extension Cords; Important Safety Instructions For All Battery Packs - DeWalt DC013-XE Instruction Manual

equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
NOTICE: Per FCC Part 15, changes or modifications to this equipment not expressly
approved by D WALT could void your authority to operate this equipment.
E
WARNING: To reduce the risk of fire or electric shock, do not expose this
apparatus to rain or moisture. Use only in dry locations.
CAUTION: To prevent electric shock, ensure mains supply is earthed and only a 3
pin plug is used .
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the
power supply corresponds to the voltage on the rating plate. 240 V AC means your
tool will operate on alternating current. As little as 10% lower voltage can cause loss
of power and can result in overheating. All D
tool does not operate, check the power supply. Your D
therefore no earth wire is required.
• Young children and the infirm. This appliance is not intended for use by
young children or infirm persons without supervision. Young children should be
supervised to ensure that they do not play with this appliance.
• Replacement of the supply cord. If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised D
to avoid a hazard.

Extension Cords

CAUTION: Use only extension cords that are approved by the country's Electrical
Authority. Before using extension cords, inspect them for loose or exposed wires,
damaged insulation and defective fittings. Replace the cord if necessary.
WALT tools are factory tested; if this
E
WALT tool is double insulated,
E
WALT Service Centre in order
E
MINIMUM GAUGE FOR CORD SETS
For Cable length (m): 7.5
Use Cable with minimum rating (Amperes)
Tool Amperes
0 - 3.4 7.5
3.5 - 5.0 7.5
5.1 - 7.0 10
7.1 - 12.0 15
12.1 - 20.0 20
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
.........direct current
...............Class I Construction
....................(grounded)
...............Class II Construction
....................(double insulated)
.../min ...........per minute
................shock hazard symbol

Important Safety Instructions for All Battery Packs

When ordering replacement battery packs, be sure to include catalog number and
voltage. Consult the chart at the end of this manual for compatibility of chargers and
battery packs.
The battery pack is not fully charged out of the carton. Before using the battery pack
and charger, read the safety instructions below. Then follow charging procedures
outlined.
READ ALL INSTRUCTIONS
2
15 25 30 45 60
7.5 7.5 7.5 7.5 7.5
7.5 7.5 7.5 10 15
10 10 10 15 15
15 15 15 20 20
20 20 20 25 –
A .............amperes
W ............watts
.........alternating current
.........alternating or direct current
n o ...........no load speed
...........earthing terminal
..........safety alert symbol
BPM ........beats per minute
RPM ........revolutions per minute