Table of Contents
Advertisement
QQ
3 7 63 1515 0
Panel Mechanism
• At Full Open, angle is vertical and Slide is at the very back.
• Panel Mecha Slide/Angle will be in 3 steps.
• OPEN/CLOSE key illumination will blink all the time.
Flicker Adjustment (When Hideaway Unit special
connected)
1) When ATT key is pressed, flicker adjustment comes On.
Monitor is slid all the way to the front, the screen mode is
ZOOM, and Video Mode is VIDEO.
2) When ATT key is pressed for the second time, flicker ad-
justment comes Off.
Monitor is slid is slid all the way to the back. (Initial position
of Test Mode.)
The screen mode is full and video will be the video changed
during adjustment.
DC Offset
• Clearing DC Offset detection (normal/abnormal)
By the use of DC Offset information clear key in the Service
Information Screen, DC Offset detection information on
TE
E2PROM will be cleared.
L 13942296513
• DC Offset detection information will be displayed on Infor-
mation screen/Service Information screen.
• During Test Mode, even if DC Offset is detected, this will
not be written to E2PROM.
• By pressing remote controller Tenkey 2 (Preset 2), the Vol-
ume setting will be switched to the following setting values.
Source: CD-CH
Designated disc: KTD-02A Designated
Track: 15 (20Hz, 0dB)
DISC/TRACK designation is conducted manually
Designated Vol: 29
www
.
TEST MODE
x
ao
u163
y
i
KVT-M707/M707Y
2 9
8
Specification to turn motor driver ON with no slide
mechanism
• In the condition where designation key is pressed down,
motor driver port is turned On.
With the [DISP] key depress, the motor is turned in forward
direction with the 1st key ON. With [DISP] key OFF, motor
stops.
With [DISP] key ON for the 2nd time, motor reverses. With
[DISP] key OFF, motor stops. This goes on thereafter.
Backup Memory
• During the Test Mode, Backup Memory function does not
work.
Clearing E2PROM contents
• E2PROM contents that should not remain at shipping is
cleared.
[SRC] key, [AUTO] key and Reset clears the memory con-
tent.
DC Offset information
Memory function
Q Q
Storefront mode information
3
6 7
1 3
1 5
Service information
co
.
9 4
2 8
0 5
8
2 9
9 4
2 8
m
9 9
9 9
19
Advertisement
Table of Contents
