Color (Day & Night); Synchronization Mode - Samsung SDN-520N Instruction Manual

S S M M
E E T T U U P P E E N N U U
Color ( Day & Night)
Your camera provides automatic mode changeover by sensing day
or night conditions. It changes to Color mode in day conditions for
optimal color and to BW mode in night conditions for clear
identification.
1. Press the SET button to display the setup menu and move the arrow
indicator to 'Color' using the UP or DOWN button.
2. Select a mode using the LEFT or RIGHT button.
ON : Color mode is kept up.
OFF : A black and white mode is kept up.
Auto1 : Select this mode under a normal light source(sunlight or
fluorescent lamp). When changing between color and
B/W, the OSD key does not act for 3 seconds.
Auto2 : Select this mode under light source that have a wavelength
range mostly above 800nm(incandescent lamp). When
changing between color and B/W, the OSD key does not
act for 3 seconds.
Camera ID
Backlight
Motion Detect.
Lens
Shutter
Gain
White Balance
Color
Sync.
3. Press the SET button.
If you set low level in Video IRIS mode, Color/BW may not change over
NOTE
automatically.
Under Gain OFF Color/BW does not change over automatically, ON/OFF is
only available.
If you change 'Gain' menu from ON to OFF, 'Color' mode change to ON.
If you change 'Gain' menu from OFF to ON, 'Color' mode change to Auto1.
Select Auto2 in 'Color' mode under incandescent lamp.
Adjust the focus if the camera is out of focus for changing modes.
36
COLOR CCD CAMERA
Setup
OFF
OFF
OFF
DC
ESC
AGC
ATW
Auto1
LL

Synchronization Mode

Two synchronization modes are available Internal and
External linelock. -In linelock mode, it synchronizes the video
signal between cameras without a synchronous generator.
The linelock synchronization is only used in the areas of
60Hz(NTSC Models)/50Hz(PAL Models).
1. Press the SET button to display the setup menu and move the arrow
indicator to 'Sync.' using the UP or DOWN button.
2. Select 'LL' or 'INT' using the LEFT or RIGHT button.
INT : Internal synchronization.
LL : External linelock synchronization.
Setup
Camera ID
Backlight
Motion Detect.
Lens
Shutter
Gain
White Balance
Color
Sync.
Reset
End
3. L.L mode Press the SET button.
S S M M
E E T T U U P P E E N N U U
OFF
OFF
OFF
DC
ESC
AGC
ATW
Auto1
LL
37
COLOR CCD CAMERA