Will Not Eject Ice (Water Frozen); Ice Is Slow To Release From Evaporator; Will Not Fill With Water; Continuous Ice Production - Electrolux Ice Maker Service Manual

Problem

6. Will not eject ice (water frozen).

Cause
7. Ice is slow to release from
evaporator.
Cause

8. Will not fill with water.

Cause

9. Continuous ice production.

Cause
Cause
a. Bin thermostat set incorrectly.
b. Wiring plug off of bypass valve
coil.
c. Defective bypass valve.
d. Deposit build-up on evaporator
grid.
a. Deposit build-up on evaporator
grid.
b. Unit not level.
a. No stand pipe in water trough.
b. Water valve is defective.
c. Water solenoid unplugged or wire
to solenoid has internal break.
a. Bin thermostat set too cold.
b. Bin thermostat sensing bulb out
of alignment.
c. Bin thermostat stuck in closed
position.
d. Ice slab too thick.
23
Correction
a. Set bin thermostat at 10:00
position.
b. Re-install plug.
c. Replace bypass valve.
d. Run unit through the clean cycle.
Use only Electrolux Ice Machine
Cleaner. If scale or mineral
deposits accumulate on grid,
cubes will not fall freely.
Remedy
a. Run unit through the clean cycle.
Use only Electrolux Ice Machine
Cleaner.
b. Level unit for even water flow.
Uneven water flow will reduce ice
rate and cause water to spill in
ice bin.
Remedy
a. Install stand pipe.
b. Replace valve.
c. Repair wiring defect.
Remedy
a. Set bin thermostat to the 10:00
position.
b. Insert bulb inside aluminum
sensor tube.
c. Replace bin thermostat.
d. Set ice thickness adjustment dial
to a lower setting. If cubes
release from grid and are too
thick, cubes might not make
contact with sensor tube
(inside of bin); therefore bin
thermostat would never be
satisfied.
Remedy