Bosch DSA-N2B20 Installation Instructions Manual page 30

30 en | Monitoring and Maintenance
1.
2.
3.
4.
- | V2 | 2009.11
Upload the new software to a Web server
If you are using VRM, place the file that contains the new version in C:\Program
–
Files\Bosch\Video Recording Manager\VRM Server\web
on your VRM Server.
– If you are not using VRM, start a Web server tool, for example MiniWebServer.exe,
select a root directory and copy the new software version into this root directory.
Example screen:
Download and install the new version on the storage controller hard disks:
Connect to the console of the storage device. To connect to the console, select Filer >
Use Command Line in the navigation panel of the FilerView administration interface.
– If you are using VRM:
On the console, enter software install http://username:password@<VRM
Server IP>/<Filename>
Replace <username> and <password> with the login information of your VRM server.
Replace <VRM Server IP> with the IP address of your VRM server and <Filename>
with the name of the file that contains the new version.
Wait a few minutes for the installation to complete.
– If you are using MiniWebServer.exe:
On the console, enter software install http://<MiniWebServer>/
<filename> and replace <filename> with the name of the software update file.
Wait until the success message displays: Installation of setup.exe-7.xxx_e.exe
completed.
Download the new software to the CF card:
On the console, enter: download.
Wait until the success message displays: Operator requested download completed.
On the console, enter: halt.
The system reboots and stops at the bootloader.
Note that no data can be written on the disks while the system is rebooting.
Installation Guide
DSDA Digital Storage Disk Arrays
Bosch Sicherheitssysteme GmbH