Technical Data; Assembly; Inserting And Removing The Battery; Positioning The Holder Of The Drive Hmi - Bosch 1 270 020 900 Original Instructions Manual

English–2

Technical Data

Drive Unit
Article number
Rated continuous
output
Output torque, max.
Rated voltage
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Drive HMI
Article number
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Lighting*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery in all country-spe-
cific versions, depending on the statutory regulations

Assembly

Inserting and Removing the Battery

For inserting and removing the battery in/from
the the eBike, please read and observe the bat-
tery operating instructions.
0 276 001 XXX | (28.9.11)
Drive Unit
0 275 007 000/
0 275 007 001
W 250
Nm 50
V= 36
°C –5...+40
°C –10...+50
IP 54 (dust and
splash water
protected)
kg 4
HMI
1 270 020 900
°C –5...+40
°C –10...+50
IP 54 (dust and
splash water
protected)
kg 0.15
V= 6
W 2.7
W 0.3

Positioning the Holder of the Drive HMI

Tighten screws 10 and 9 with a tightening
torque of 1 Nm (max.). Otherwise, the hold-
er 2 can become damaged.
Moving/Tilting the Holder (see figure A)
Loosen both screws 9 on the bottom side of
holder 2. Move the holder on the handlebar or
change the holder angle. Retighten both screws
9 again with a tightening torque of 1 Nm (max.).
Turning the Holder (see figure B)
Loosen screw 10 on the top side of holder 2.
Turn the top part of the holder in such a manner
that the drive HMI 1 is well in your view after in-
serting it (see "Inserting and Removing the Drive
HMI"). Retighten screw 10 again with a tighten-
ing torque of 1 Nm (max.).
Inserting and Removing the Drive HMI
(see figure C)
To insert the drive HMI, place it turned by approx.
30° onto holder 2 and then turn it clockwise to
the stop.
To remove the drive HMI, turn it approx. 30° anti-
clockwise and pull it out of the holder 2.
Remove the drive HMI when parking the
eBike, so that the drive cannot be used by
unauthorised persons. Without the drive
HMI, the drive cannot be switched on.
Checking the Speed Sensor (see figure D)
The speed sensor 11 and its spoke magnet 12
must be mounted in such a manner that the
spoke magnet, after a turn of the wheel, moves
past the speed sensor with a clearance of at
least 5 mm, yet no more than 17 mm.
Note: If the clearance between speed sensor 11
and spoke magnet 12 is too small or too large,
or if the speed sensor 11 is not properly con-
nected, the speed indication a will fail, and the
eBike drive will operate in emergency mode.
In this case, loosen the screw of the spoke mag-
net 12 and fasten the spoke magnet to the
spoke in such a manner that it runs past the
mark of the speed sensor at the correct clear-
ance. When the speed is still not being indicated
in the speed indication a after this, please refer
to an authorised bicycle dealer.
Bosch eBike Systems