Yamaha RX-A1040 Quick Manual page 2

■ Connections
Caution
• Before connecting the speakers, remove the unit's power cable from the AC wall outlet.
• Ensure that the core wires of the speaker cable do not touch each other or come into contact with the
unit's metal areas. This may damage the unit or the speakers.
• Connect the speakers with the correct polarity.
1
Connect the speaker in Zone2 to the EXTRA SP terminals with
speaker cables.
The type of the speaker terminals varies depending on the model.
The unit (rear)
Left
To connect speaker cables
c
R
Z O
B I– N E
2 /F
+ (red) A M
b .P R
P E S
E X E N
T R C E
A S
/
P
L
a a
d
- (black)
2
EXTRA SP terminals
ZONE 2/F.PRESENCE/
R L
BI–AMP
EXTRA SP
Right
Speakers (Zone2)
2
Connect the playback devices (such as CD players) in the main zone
to the analog stereo input jacks with stereo pin cables.
Only analog audio sources (including FM/AM radio), and USB and network
sources can be output to Zone2. To listen to the playback of an external device
in Zone2, you need to connect the device to the analog audio input jacks.
Analog stereo input jacks
(such as AUDIO 1–4)
The unit (rear)
L
L
R
R
3
Connect the power cable to an AC wall outlet.
To operate the unit from Zone2
You can operate the unit from Zone2 using the supplied remote control if you connect
an infrared signal receiver/emitter to the unit's REMOTE IN/OUT jacks. For details, refer
to the Owner's Manual in the supplied CD-ROM.
Playback device
L
(such as a CD player)
L
R
R
AUDIO
OUT