Case Or Front Panel Replacenlent - HP 340 Series Service Manual

Installation
To install the case:
1. Set the case on its bottom.
2. Ensure the RAM boards are fully seated in their connectors.
3. Start the internal assembly into the case.
4. Align the rails under the processor board with the rail guides in the bottom of the case.
5. Slide the internal assembly all the way into the case.
6. Install and fasten the seven rear panel screws.
Case or Front Panel Replacement
If the case or front panel is damaged, both parts must be replaced. The front panel cannot be
removed from the case without damaging the metal fingers in the case. To replace either the
case or front panel, these new parts are needed:
• Case.
• Front panel.
• Name label.
• Regulatory Label
Preliminary Requirements
Turn OFF the SPU and remove these items in the order listed:
1. Power cord.
2. Case.
Installing the Front Panel
1. Align the new front panel's attaching pins with their holes in the front of the case.
2. Press the front panel firmly and completely on to the case.
3. Remove the molded feet from the old case by unsnapping them from the bottom.
4. Install the molded feet into the new case.
5. Remove the new name label from its backing and press it into place in the upper left-hand
recess on t he front panel.
6. Remove the new regulatory label from its backing and press it into place on the bottom
of the case over the voltage select switch hole like the old case.
7. Install the internal assembly in the case.
30
Assembly Replacement