NEC EXPRESSSCOPE Engine 3 User Manual page 49

Followings describe how to confirm and modify the DHCP setting for management LAN
through the command line interface. To move the current default target to
/admin1/sp1/enetport1/lanendpt1/ipendpt1, enter the following command at the command
prompt:
cd /admin1/sp1/enetport1/lanendpt1/ipendpt1
Enter the following command, if you would like to confirm properties of the DHCP target
which is /admin1/sp1/enetport1/lanendpt1/ipendpt1.
show
Enter the following command if you would like to modify a property of the DHCP target.
set <Property>=<New value>
The properties which the DHCP target contains are as follows:
• AddressOrigin
This specifies whether DHCP is enabled for the management LAN. Note that, the valid
values for this property are "3" and "4". "3" means that the DHCP is disabled. "4"
means that the DHCP is enabled. This is the dynamic setting.
• IPv4Address
This specifies the IP address for the management LAN. This property is read-only.
• SubnetMask
This specifies the subnet mask for the management LAN. This property is read-only.
For example, enter the following command when you would like to enable DHCP.
set AddressOrigin=4
Followings describe how to confirm the gateway setting for management LAN through the
command line interface. To move the current default target to
/admin1/sp1/enetport1/lanendpt1/ipendpt1/gateway1, enter the following command at the
command prompt:
cd /admin1/sp1/enetport1/lanendpt1/ipendpt1/gateway1
Enter the following command, if you would like to confirm properties of the gateway target
which is /admin1/sp1/enetport1/lanendpt1/ipendpt1/gateway1.
show
The properties which the gateway target contains are as follows:
• InfoFormat
The value is "3". This specifies the AccessInfo is IPv4 address. This property is
read-only.
- -
49