Samsung SCB-5003 User Manual page 27

- DISP ID : Display camera title on top left corner of the screen.
- FONT COLOR : You can change the OSD font color. (White, Yellow, Green,
- LANGUAGE : You can select the menu language according to your requirements.
- RETURN : Return to the SPECIAL menu.
Comm aDJ (Communication adjustment) :

This function sets up the camera communication status when controlling the
camera through an external control device.
❶
If the SPECIAL menu screen is
displayed, use the Function Setup
switch so that the arrow indicates
'COMM ADJ'.
Select a desired mode using the
❷
Function Setup switch.
- PROTOCOL : Select the
communication
PROTOCOL.
(SAMSUNG-T, SAMSUNG-E, PELCO-D, PELCO-P, BOSCH,
HONEYWELL, VICON, PANASONIC, GE and AD)
- CAM ID : Determines the camera's identification number (between 0 and 255).
- BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps .
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- RET PKT : Determines whether to send a command back to the controller device
when a communication control command is sent to the camera.
- COAX : You can select whether to use COAX communication.
- RETURN : Return to the SPECIAL menu.
imagE aDJ

❶
If the SPECIAL menu screen is
displayed, use the Function Setup
switch so that the arrow indicates
'IMAGE ADJ'.
❷ Select a desired mode using the
Function Setup switch.
- GAMMA : The setting range is 0.2 ~
1.0. The closer to 1.0 the
setting is, the darker it gets.
Red, Blue)
COMM SETUP
PROTOCOL
▶ 1.
CAM ID
2.
BAUD RATE
3.
UART MODE
4.
RET PKT
5.
6. COAX
RETURN
7.
IMAGE SETUP
GAMMA
▶ 1.
PED LEVEL
2.
COLOR GAIN
3.
4. H-REV
5. V-REV
6. D-ZOOM
7. SHARPNESS
8. PFR
RETURN
9.
SAMSUNG-T
1
------

9600
8-N-1
ENABLE
ON
0.45
50
---- ----

50
---- ----

OFF
OFF
OFF
MIDDLE
OFF
English_2