Installation; Technical Specifications; Troubleshooting; Safety Instructions - Siemens Dryer Operating And Installation Instructions

Installation

Technical specifications

Included in standard delivery: dryer, operating and installation instructions. F
Mains plug not inserted!
Check dryer for damage which may have been caused in transit!
Dryer is heavy. Do not lift it by yourself!
Beware of sharp edges!
Do not install in a room where there is a risk of frost! Freezing water may result in damage!
If in doubt, have a technician connect the appliance!
Do not lift the dryer by projecting components (e.g. door) - risk of breakage!
Installing the dryer
Take all accessories out of the drum.
1.
Drum must be empty!
Mains plug must be accessible at all times!
F
Place the dryer on a clean, level and firm surface!
Do not obstruct cooling grille at the front of the dryer.
Keep the area around the dryer clean.
Align the dry with the height adjustable feet.
Use a spirit level.
Never remove the height adjustable feet!
Clean and level
Do not obstruct
cooling grille
Mains connection
2. see Safety instructions, page 11.
Connect correctly to an a.c. earthed socket. If in doubt, have the socket checked by an
electrician!
Mains voltage must correspond with the voltage specifications on the appliance rating plate
(see page 9)!
Wattage and required fuse are indicated on the appliance rating plate.
Switching over the connected load
3.
10/16 ampere Check your socket fuse!
F
Set to Off 1 x clockwise Hold selected and 3 x clockwise Set ampere Set to Off
If required, select
Optional accessories
Display field repeatedly.
Feedback signals
10 A off
Order no.
(depending on model)
flashes flashes
16 A WZ WZ
20160 20160
Frost protection/ Do not operate the dryer
if there is a risk of frost!
WZ WZ
transportation
20310
Preparation
WZ
1.
Empty condensation container, see page 4.
20300
2.
Set programme selector to any programme.
3.
Select M start button -> condensation is pumped into the container.
WZ WZ
4. Wait 5 min., empty condensation container again.
20290 20290
5. Set programme selector to Off.
7
What to do if ...
Repairs may be carried out by customer service or authorised technicians only!
Dimensions (D x W x H) 60 x 60 x 85 cm (height adjustable)
Weight (net) approx. 45 kg
Before you call customer service, please check whether you can correct the fault yourself.
Max. capacity 7 kg
A technician will charge you for advice, even during the warranty period. Please give customer
Condensation container 4.2 l
service the product number (E Nr.) and the production number (FD) of the appliance
Supply voltage (see inside of door).
Connected load
F M start indicator light does
Fuse See appliance rating plate
not come on.
Product number (E Nr.)
Production number (FD)
The appliance rating plate is situated on the rear of the dryer. F b (Container) and M start
indicator lights are flashing.
Consumption values Specifications are approximate values determined under
o (Filter) and M start
normal conditions. Fluctuations up to 10% are possible. F
indicator lights are flashing.
Spin speed Drying time in min. Energy consumption
r.p.m. (residual with 8 min. cooling in kWh F Dryer does not start.
humidity) time
10 A 16 A 10 A 16 A
y Cottons/Coloureds 7 kg
Ç (Cupboard Dry*) 1400 (approx. 50%) 112 89 3.36 3.36
F Water is running out.
1000 (approx. 60%) 131 104 3.92 3.92
800 (approx. 70%) 150 120 4.48 4.48
F Door is opening by itself.
f (Iron Dry*) 1400 (approx. 50%) 93 69 2.42 2.42
1000 (approx. 60%) 111 82 3.06 3.06
F Degree of dryness was not
800 (approx. 70%) 130 94 3.70 3.70
reached or drying time too
A Easy Care 3,5 kg
long.
Ç (Cupboard Dry*) 800 (approx. 40%) 48 42 1.35 1.35
600 (approx. 50%) 60 51 1.65 1.65
* Test programmes according to DIN EN 61 121 and IEC 61 121
Drum light
(depending on model)
(Bulb E14, 15 W)
The drum is lit when the door is opened and closed or when the programme starts; it goes out
automatically.
F Washing damp.
F Humidity in the room
is increasing significantly.
Connection fittings for condensation outlet
The condensation is conveyed directly via a hose.
F One or more indicator lights
Connection set for washing drying column for programme status are
flashing.
To save space, the dryer can be placed on a suitable washing machine which has the same
depth and width.
F Does the interior light
Same as WZ 20310 but with removable worktop. (depending on model) work?
If you cannot correct a fault yourself or if a repair is required:
Cover for appliance underneath worktop
Set programme selector to Off.
Pull out the mains plug.
The dryer can be built under the worktop in a line of kitchen units.

Safety instructions

Emergency Immediately pull out mains plug or interrupt fuse.
Use dryer in the house.
ONLY ... for drying textiles.
NEVER ... use dryer for other purposes than those described above.
modify the technology or properties of the dryer.
Hazards Children and uninstructed persons must not use the dryer.
Is the mains plug inserted?
Do not leave children unattended near the dryer.
Programme selected?
Keep pets away from the dryer.
Check fuse in the house.
Take all objects out of the pockets. Look out for cigarette lighters
Empty condensation container. -> risk of explosion!
Do not lean or sit on the door -> risk of dryer tipping over!
If featured, check hose for condensation outlet.
Open the door carefully. Hot steam may escape.
Clean air cooler, page 6 Servicing and cleaning".
Frost damage possible below 0 °C.
Installation
Clean fluff filter, page 4.
Attach loose cables or hoses, otherwise risk of tripping.
M start button selected?
Mains Connect the dryer correctly to an a.c. earthed socket, otherwise safety
connection cannot be ensured.
Door closed?
Cable cross section must be adequate.
Programme set?
Use residual current operated circuit breaker with this symbol only:
Ambient temperature higher than 5 °C?
Mains plug and socket must match.
Align dryer horizontally. Do not use multiple plug/couplings and/or extension leads.
Do not take hold of the mains plug with damp hands.
Clean air cooler seal.
Never pull the mains plug out of the socket by tugging the cable.
Press door until it clicks" into position.
Do not damage the power cord.
Operation Load the drum with washing only. Check the contents before switching on
Clean fluff filter/air cooler, page 4/6.
the dryer.
Empty condensation container.
Do not use the dryer if the washing has come into contact with solvent, oil,
wax, grease or ink (e.g. setting lotion, nail varnish remover, stain remover,
Check water outlet (if featured).
Ambient temperature above 30 °C -> adequate ventilation. solvent naphtha, etc.) -> risk of fire/explosion!
Dust hazard (e.g. coal dust, flour): do not use the dryer -> risk of explosion!
Cooling grille may be blocked -> unblock.
Do not use the dryer if the washing contains foam/rubber -> elastic material
Unsuitable programme set? Page 7.
may be destroyed and the dryer may be damaged by possible deformation
Dryer installation too restricted? Provide air circulation.
of the foam.
Power failure -> restart dryer. Switch off the dryer when the programme ends.
Do not drink the condensation!
Fine layer of limescale on the moisture sensors ->
clean the moisture sensors, page 6. Defect Do not use the dryer if it is defective or considered to be defective;
repairs by customer service only.
Use next higher drying programme or also the time programme,
Do not use the dryer if the power cord is defective. To prevent hazards,
page 7.
have a defective power cord replaced by customer service only.
Warm washing feels damper than it actually is!
Before changing the interior light bulb, always pull the mains plug out of the
Ventilate room adequately. socket.
Spare parts For reasons of safety use original spare parts and accessories only.
Cooling grille blocked? -> Unblock.
Ensure that the air cooler has been inserted. Disposal Dryer: pull out the mains plug, then sever the power cord on the appliance.
Dispose of at a public waste disposal centre.
Clean filter and air cooler, page 4/6.
Packaging: do not allow children to play with packaging parts
Check installation conditions, page 8.
-> risk of suffocation!
Switch off, leave to cool down, switch on again, All materials are environmentally friendly and recyclable.
restart programme. Dispose of in an environmentally friendly manner.
Pull out the mains plug.Open cover inside the appliance above
the door (with a Torx 20 screwdriver) and change the bulb.
Close the cover flap.
Follow instructions on
page 11!
7
Dryer
Operating
en
and installation instructions
Read these instructions before switching on the dryer!