42.If necessary, remove two (2) bearings from PTO
gear. Discard removed bearings. Remove retaining ring
from groove in PTO gear bore.
43.Remove two (2) plugs from transmission pump
housing. Remove and discard O--rings from plugs.
44.Remove three (3) socket head screws that secure
both side covers to transmission pump housing.
45.Carefully slide side covers from trunnion shafts and
housing. Remove and discard O--rings from side cov-
ers.
46.Remove retaining rings that secure oil seals into both
side covers. Remove oil seals from side covers. Discard
seals.
Hydraulic System
1
2
1. Bearing
2. PTO gear
2
1. Socket head plug
2. Hex plug
4
5
1. Side cover
2. O- -ring
3. Pump housing
Page 4 - - 88
3
1
Figure 87
3. Retaining ring
3
1
Figure 88
3. Pump housing
2
3
Figure 89
4. Retaining ring
5. Oil seal
Groundsmaster 360
1