Quick Reference Guide
Tighten the Finger Strap.
2.
NOTE When using the Imager for the first time, after power up, press and release
the Scan Trigger to enable the manual triggering mode (this operation
disables the default auto triggering mode).
Getting Started - Corded Configuration
In order to start using the Imager you must install the Corded Adapter.
Connect Corded Adapter
Align the Corded Adapter on top of the
1.
Imager.
Push the Corded Adapter all the way
2.
into the Locking Slots of the Imager.
Firmly press the Corded Adapter into the
3.
Imager until a "click" is heard ensuring
the Adapter Release Latch is fully
engaged with the Imager.
Remove the Corded Adapter
Hold the Imager in one hand.
1.
Press the Adapter Release Latch.
2.
Pull up the Corded Adapter to release
3.
from the Locking Slots of the Imager.
Finger
Strap
Adapter Release
Latch
9
Corded
Adapter
Locking Slots