4.2.2 Su Board; Remote Control Installation For - Bosch Remote Control User Manual

6720606990-1005_(Remote control).fm Page 8 Thursday, July 1, 2010 11:46 AM
Remote control installation
B On heater control panel press and
hold Program key
while turning on the power switch (I).
Release program key when LCD
displays "188".
LCD shows "P2". If not, repeat
previous step.
B Select "P3" using buttons
on heater.
B Press and hold Program key
or again for 1 sec.
LCD shows one number and one
rotating digit. If not, repeat previous
step.
The number represents the remote
control which is to be registered, the
first remote control will be registered
with number "0", the second with
number "1" and so on.
The rotating digit shows that the
electronics is expecting a registration.
If the LCD fails to show a number and
rotating digit after repeated attempts,
double check the wire connections
made in section 4.1.
B Hold remote control in front of the
control panel on the heater and
simultaneously press remote control
buttons and
temperature indication is shown on
the remote control LCD.
8
B Switch power
or appliance to the "OFF" (0) position
and then back "ON" (I).
B Press buttons
to reach desired temperature.
New remote control is programmed.

4.2.2 SU board

and
B Connect power to heater.
B Move the main switch on the
appliance to the "OFF" (0) position.
B Press and hold
same time turning the main switch to
"ON" position (I).
LCD shows one number and one
rotating digit. If not repeat previous
step.
The number represents the remote
control which is to be registered, the
first remote control will be registered
with number "0", the second with
number "1" and so on.
The rotating digit shows that the
electronics is expecting a registration.
If the LCD fails to show a number and
rotating digit after repeated attempts,
until the
double check the wire connections
made in section 4.1.
B Hold remote control in front of the
control panel on the heater and
switch on the
or in order
key while at the
6 720 606 990