D-Link NetDefend DFL-210 Cli Reference Manual page 102

3.22.5. L2TPClient
Network
RemoteEndpoint
TunnelProtocol
OriginatorIPType
OriginatorIP
DNS1
DNS2
Username
Password
PPPAuthNoAuth
PPPAuthPAP
PPPAuthCHAP
PPPAuthMSCHAP
PPPAuthMSCHAPv2
MPPENone
MPPERC440
MPPERC456
MPPERC4128
DialOnDemand
ActivitySensing
IdleTimeout
Metric
AutoInterfaceNetworkRoute
MTU
The network from which traffic should be routed into the tun-
nel.
The IP address of the L2TP/PPTP server.
Specifies if PPTP or L2TP should be used for this tunnel.
(Default: PPTP)
Specifies what IP address to use as source IP in e.g. NAT.
(Default: LocalInterface)
Manually specified originator IP address to use as source IP
in e.g. NAT.
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Specifies the username to use for this PPTP/L2TP interface.
The password to use for this PPTP/L2TP interface.
Allow no authentication for this tunnel. (Default: No)
Use PAP authentication protocol for this tunnel. User name
and password are sent in plaintext. (Default: Yes)
Use CHAP authentication protocol for this tunnel. (Default:
Yes)
Use MS-CHAP authentication protocol for this tunnel.
(Default: Yes)
Use MS-CHAP v2 authentication protocol for this tunnel.
(Default: Yes)
Allow authentication without Microsoft Point-to-Point En-
cryption (MPPE). (Default: Yes)
Use an RC4 40 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 56 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 128 bit MPPE session key with MS-CHAP or
MS-CHAP v2 authentication protocol. (Default: Yes)
Enable Dial-on-demand which means that the L2TP/PPTP
tunnel will not be setup until traffic is sent on the interface.
(Default: No)
Specifies if the dial-on-demand should trigger on inbound or
outbound traffic or both. (Default: BiDirectional)
Idle timeout in seconds for dial-on-demand. (Default: 3600)
Specifies the metric for the auto-created route. (Default: 90)
Automatically add a route for this interface using the given
remote network. (Default: Yes)
Specifies the size (in bytes) of the largest packet that can be
passed onward. (Default: 1500)
92
Chapter 3. Configuration Reference