Kenwood KAC-526X Instruction Manual
  1. Manuals
  2. Brands
  3. Kenwood Manuals
  4. Car Amplifier
  5. KAC-526X
  6. Instruction manual
Kenwood KAC-526X Instruction Manual

Kenwood KAC-526X Instruction Manual

Kenwood power amplifier instruction manual
Hide thumbs Also See for KAC-526X:
Table of Contents

Advertisement

Quick Links

KAC-726
KAC-526X
POWER AMPLIFIER
INSTRUCTION MANUAL
© B64-1213-00 (EM)

Advertisement

Table of Contents
loading

Related Manuals for Kenwood KAC-526X

Summary of Contents for Kenwood KAC-526X

  • Page 1 KAC-726 KAC-526X POWER AMPLIFIER INSTRUCTION MANUAL © B64-1213-00 (EM)

  • Page 2: Safety Precautions

    NOTE If you have difficulty in installing this unit in your vehicle, contact your Kenwood dealer. Cleaning the unit If the surface is dirty, wipe it clean with a silicon cloth or soft dry cloth with the power off.

  • Page 3: Installation Procedure

    Installation procedure 1. Remove the ignition key and disconnect the negative short circuits. 2. Set the unit according to the intended usage. 3. Connect the input and output cables of the units. 4. Connect the speaker cables. 5. Connect the power cable, power control cable and grounding cable following this order. 6.

  • Page 4: Input Sensitivity Control

    Controls Operations of the following control and switches are required in accordance with the center unit and speakers connected with this unit. OPERATION FILTER STEREO KAC-726 KAC-526X FUSE(20A x 2) KAC-726 FUSE(15A) BATT KAC-526X 1 RCA cable ground lead terminal 2 FILTER switch These switches allow filtering of the speaker output signals.

  • Page 5: Protection Function

    5 LINE IN terminal 6 Speaker level input terminals 7 Fuse (20 A 2 : KAC-726) Fuse (15 A : KAC-526X) 8 Battery terminal 9 Ground terminal 0 Power control (REMOTE) terminal ! SPEAKER OUTPUT terminals Protection function This unit is equipped with a protection function for protecting this unit and your speakers from various accidents or problems that can occur.
  • Page 6 Connection RCA cable connection 2CAUTION Do not connect cables and leads to both RCA cable input jacks and the speaker input terminals simultaneously, for this may cause malfunction or damage. Left input FILTER STEREO RCA cable ground terminal When using an RCA cable with a ground lead attached, connect the ground lead to this terminal.
  • Page 7 Power and Speakers cable connection Power control (REMOTE) lead terminal Terminal cover Power control cable Battery cable (Yellow) • If a buzzing noise is heard from the speakers when the engine is running, connect a line noise filter (optional) to each of the battery cable. •...

  • Page 8: System Examples

    System examples Full-range 2-channel system Switch setting FILTER OPERATION CENTER UNIT STEREO MONO(Lch) High-power full-range 2-channel system Switch setting OPERATION FILTER CENTER UNIT MONO(Lch) STEREO Full-range 2-channel + Subwoofer system Switch setting FILTER OPERATION CENTER UNIT STEREO MONO(Lch) Tri-mode Switch setting FILTER OPERATION STEREO...

  • Page 9: Troubleshooting Guide

    + / - polarity. • A speaker cable is pinched by a screw in the car body. • The switches may be set improperly. KAC-726 KAC-526X KAC-726 KAC-526X 300 mm SOLUTION • Connect the input (or output) cables.

This manual is also suitable for:

Kac-726

Table of Contents