Clean the corona assembly wires
Clean the corona assembly wires
If streaks appear on the printed output or parts of the printed image are missing, clean the corona
assembly wires inside the print module.
It takes approximately 35 seconds to clean the wires.
Before you begin
Make sure the print system does not process any jobs.
Procedure
1.
Touch [System] -> [Maintenance].
2.
Touch [Start maintenance].
3.
Enter your maintenance PIN.
4.
Touch [Clean the corona wires].
5.
Follow the wizard steps.
6.
Close the menu.
After you finish
NOTE
If the procedure displays an engine error, contact your local service representative.
222
Chapter 7 - Maintain the print system
imagePRESS C800 Series