Kenmore 1020 Owner's Manual page 5

_B
WINDING THE BOBBIN
,
,
.
®
®
®
®
Draw thread from spool through
bobbin winder tension disc as shown
in Fig. 1.
Pull end of thread through hole in
bobbin and place bobbin onto
bobbin winder shaft with end of
thread coming from the top of the
bobbin, fitting the notch on the
bobbin over locking stud on the
shaft as shown in Fig. 2.
Push bobbin winder latch against
bobbin until it clicks.
4. Release clutch by pulling hand wheel
or turning clutch knob as shown in
Fig. 4. Start machine, holding onto
end of thread. When bobbin is
slightly filled, release end of thread.
5. When bobbin is full, winding
mechanism stops.
6. Push in hand wheel or turning clutch
knob to return to stitching position.
Remove bobbin.
4