Connecting A Non-Kenwood Receiver To Entre; Connecting A Kenwood Sovereign Dvd Changer To Entre; Sovereign Dvd Changer - Kenwood Sovereign Entre Connection And Setup Manual

How Do I Connect to My Kenwood Sovereign DVD Changer and a Non-Kenwood Receiver?, continued
How Do I Connect to My Kenwood Sovereign DVD Changer and a Non-Kenwood Receiver?, continued
Do not plug in Entre or devices to AC power until you have connected all your
devices.
This section focuses on the connections from your Kenwood Sovereign DVD
changer and a non-Kenwood receiver to Entre. Please refer to your receiver and
DVD player's instructions for more detail about their connection jacks and
capabilities.
Though the diagram on page 8 shows a DV-5900M DVD
changer, you can connect a DV-5050M changer to En&6 as
well.
Connecting a Non-Kenwood Receiver to Entr6
Review the information under "Before making any video connections to the
TV". It contains important notes about the types of connections you can make.
1.
Examine the receiver's available inputs and outputs. Select an input set for
Entre that has an optical digital input, analog play (tape monitor) outputs,
and analog record (tape monitor) inputs associated with it. Note which
input you select: this will become the receiver's Entre input.
2. Connect one of the included optical digital cables from the receiver's OPTI-
CAL DIGITAL Out jack to Entre's DIGITAL OPTICAL In jack and connect
the other included optical digital cable from Entre's DIGITAL OPTICAL Out
jack to the receiver input's OPTICAL DIGITAL jack, as shown.
Be sure to remove the protective cover from the optical jack
before connecting. Please retain the cover and store it in a safe
place.
3. Connect the video cable from the receiver's MONITOR OUT jack to the TV
or Monitor's VIDEO IN jack as shown. Use the same type of connection
that you use between Entre and the receiver.
4. Connect one stereo audio cable from the receiver's ANALOG RECORD
OUTPUT jacks to Entre's ANALOG REC IN jacks, as shown. Connect
another stereo audio cable from Entre's ANALOG PLAY OUT jacks to the
receiver's ANALOG PLAY INPUT jacks, as shown.
If you don't use Entre's analog connections, you may not be
able to record certain copy-protected media that can only be
recorded using Entre's analog inputs.
5. Connect one video cable from the receiver's VIDEO INPUT to Entre's
VIDEO OUTPUT, as shown.
Connecting a Kenwood Sovereign DVD Changer to Entr6
1,
Connect a digital audio cable from the changer's DIGITAL COAXIAL OUT
jack to Entre's DIGITAL COAXIAL IN jack, as shown.
2. Connect a video cable from the changer's VIDEO OUTPUT jack to Entre's
COMPOSITE VIDEO INPUT jack, as shown.
3. Connect the included RS-232C cable from the changer's RS-232 jack to
Entre's RS-232 jack as shown.
Since the DVD player makes a digital connection to Entre,
Entre must make additional digital input and output
connections to the receiver. See step 2 in "Connecting a Non-
Kenwood Receiver to Entre"on this page.
Connecting a Non-Kenwood Receiver to a Kenwood
Sovereign DVD Changer
Connect three stereo audio cables from the receiver's 6-CHANNEL
ANALOG INPUT to the DVD changer's 6-CHANNEL ANALOG OUTPUT as
shown.
If you have a DV-5050M, connect one stereo audio cable
from the DVD player's MIX LINE OUTPUT to the receiver's
DVD analog input.
How to Connect and Set Up Your Entre Entertainment Hub
9