Moving The 1U Integrated Keyboard Drawer Installed In A Rack - HP 1U User Manual

Care and Maintenance
Moving the 1U Integrated Keyboard Drawer Installed
in a Rack
When moving the 1U Keyboard Drawer installed in the rack, HP recommends that
you install the lock plates. The lock plates are included in your kit and should be
installed on each side of the unit and rack.
To install the lock plates:
1. Fully extend the sliding rails until they lock.
2. Place the lock plate behind the corner of the front plastic bezel, making sure the
top and bottom holes are aligned with the pins.
3. Insert one 6-32 screw into the middle hole on the lock plate, securing it to the
unit (1).
4. Insert one M-6 screw to the other end of the lock plate, securing the unit to the
rack (2).
5. Repeat steps 2 through 4 to install the other lock plate.
Figure 4-1: Installing the lock plates
4-2
1
2
HP 1U Integrated Keyboard Drawer User Guide