PROBLEM
•
The PS is beeping.
•
Poor audio quality.
•
A ringing call suddenly
stops when moving
between CS/repeater
zones.
•
When talking and moving
between zones, you hear
an alarm or continuous
noise, or your call is
disconnected.
PROBABLE CAUSE
•
The verification tone is
turned on.
•
The CS is out of range.
•
The PS is out of range.
•
There is a delay when
moving from a CS zone to a
repeater zone when
receiving a call in group ring
mode.
•
The new zone is "busy", so
handover cannot occur.
SOLUTION
•
Turn the verification tone off (refer to
"ID Confirmation/Verification Tone
Mode").
•
Move the repeater closer to the CS.
•
Move the PS closer to the repeater.
•
Answer the call before moving between
CS/repeater zones.
•
Return to the original zone and
continue your call.
Installation Manual
6 Troubleshooting
23