Siemens Hicom 150 H Operating Instructions Manual page 2

%HIRUH#<RX#%HJLQ
These Operating Instructions describe which functions can be used with the Hicom 150 H
Version 1.2 with commercially available dial pulsing or touch tone telephones.
You may find that some functions you wish to use are not available on your telephone. This
may be due to one of the following reasons:
• The function has not been configured for your telephone - address any questions to
Customer Support.
• Your communication system does not support this function - contact your Siemens
sales representative to upgrade your system.
For the basic operating functions of your telephone please refer to the relevant operating
instructions.
When performing the various operations, you should note carefully which telephone you
have, which mode it is set to, or both (see manufacturer's specifications and instructions).
+RZ#WR#8VH#WKHVH#2SHUDWLQJ#,QVWUXFWLRQV
6WHS#E\#6WHS
5
You will find a graphic representation of the steps
in logical sequence in the left column. Below is an
explanation of the symbols:
Lift the handset (off-hook).
Replace the handset (on-hook).
Conduct a call.
Enter a telephone number or code.
Enter the code.
( ) Press the consultation hold key, signal key, flash key
(not applicable to pulse telephones).
You hear a tone.
A long tone (positive confirmation tone) confirms that
you have successfully activated a function or procedure.
A short tone (negative confirmation tone) indicates that
the function or procedure was rejected.
Dial pulsing telephones
= Code
= Code