Sony MZ-R37 Service Manual page 14

Unit LCD display
XX XX AUDIO
Adjustment value
(The data can be changed/written when flashing.)
Mode No.
(Lower two digits are displayed.)
3. Press the keys below to change the mode number.
( : Increases the one place.
p
: Sets the one place to 0.
This key brings the ten place to 0 if the one place
is 0.
VOLUME + : Increases the ten place by 10 if the one place is 0.
Increases the adjustment value if the one place is
non-zero.
VOLUME – : Decreases the ten place by 10 if the one place is 0.
Decreases the adjustment value if the one place is
non-zero.
• How to Adjust in the Audio Mode
1. When the audio mode is set to the appropriate mode for each
adjustment, the lower tow digits of the mode No. and the value
stored in EEPROM are displayed and flashing.
2. Change the adjustment value with VOLUME + or – key and
press P key to write the new value to EEPROM.
• How to Check in the Audio Mode
The audio mode allows the checks below to be performed:
1. For the mode numbers of 111 to 113, 115 and 116, pressing P
key will activate a beep. But for the mode number of 117, press-
ing P key will not activate a beep. (No beep sounds when
c HOLD switch is put on.)
2. For the mode numbers of 121 to 124, pressing Digital MEGA
BASS key will display the DBB mode for the adjustment value.
1 : Mode 1
2 : Mode 2
13 : OFF
(This will not be accepted when the LINE OUT jack is plugged.
The display will be 13 : OFF when LINE OUT jack is plugged
in Modes 1 and 2.)
(3) Mechanism Mode
• How to Transfer the Mode in the Mechanism Mode:
Mode No. Test Description
200 FUNCTION
210 MECHA test
211 HEAD adjustment
212 REC position
220 RESUME
221 RESUME CLEAR Resume clear/initialization
1. Go into the test mode.
2. Press + or VOLUME + and VOLUME + and VOLUME
+ in this turn to set the mechanism mode.
Unit LCD display
XX XX MECHA
3. Press the keys below to change the mode No.
( : Increases the one place.
p
: Sets the one place to 0.
This key brings the ten place to 0 if the one place is
0.
VOLUME + : Increases the ten place by 10 if the one place is 0.
Increases the adjustment value if the one place
is non-zero.
VOLUME – : Decreases the ten place by 10 if the one place is 0.
Decreases the adjustment value if the one place is
non-zero.
• How to Check in the Mechanism Mode
The mechanism mode allows the checks below to be performed:
1. For the mode numbers of 200, 210 to 212, 220 and 221, pressing
= key will move the optical pickup to the inner radius.
Pressing + key will move the pickup to the outer radius.
2. For the mode numbers of 211 and 212, pressing P key will
start aging. Pressing p key will stop aging.
• Mode No. 211 ... Sled aging with stepper at playback position.
• Mode No. 212 ... Sled aging with stepper at recording position.
3. With the mode number 210 selected, pressing P key will start
aging with steeper at between home and recording positions.
p key will stop aging.
– 14 –
Operation
Stepper control
Initial position return
Operation variation changing (19)
Recording head descent
Resume
( ) : Default value
Adjustment value
Mode No.
(Lower two digits are displayed.)