To Set Up Speaker Balance - Samsung HT-DM150 Instruction Manual

DM150(GB)-noRDS 7/27/02

To set up Speaker Balance

To set up Speaker Balance
Press the Sound Edit button.
•
Each time the button is pressed, the selection switches as shown below.
Example: 5.1CH Sound Setup
PRO LOGIC
D I G I T A L
LINEAR PCM
L C R
LFE
LS S RS
Front Speakers: L level, R level
PRO LOGIC
D I G I T A L
LINEAR PCM
L C R
LFE
LS S RS
Rear Speakers: L level, R level
PRO LOGIC
D I G I T A L
LINEAR PCM
L C R
LFE
LS S RS
PRO LOGIC
D I G I T A L
LINEAR PCM
L C R
LFE
LS S RS
PRO LOGIC
D I G I T A L
LINEAR PCM
L C R
LFE
LS S RS
Subwoofer Speaker
The display changes depending on the current audio output
mode (DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).
Speaker Setting Methods
Press the Test Tone button.
•
The test signal will be sent to the Left Front
Front Right Rear
To End the
Test Tone
•
Press the Test Tone button again.
33
12:20 Page 33
1
OFF, range of – 6 ~ 0
OFF, range of – 6 ~ 0
range of – 6 ~ – 00 ~ +6
Center Speaker
range of – 6 ~ – 00 ~ +6
Rear Speakers
range of – 6 ~ – 00 ~ +6
Left Rear Subwoofer in that order.
While in DSP or PRO LOGIC mode, TEST TONE may
operate differently for VCDs or CDs.
Sound Edit
2
Use the Left/Right (
adjustment.
Test Tone
Center Right L
Test Tone
LS
/ ) button to make
C R
SUB
WOOFER
RS