Advertisement
features
Sophisticated feature-rich LCD Colour
Touchscreen panel.
DTP100 facia accommodates practically
any flat architectural surface medium.
Controls 255 areas, 255 channels per
area, 96 scenes per area, 250 events, 8
tasks.
Full access to Microsoft Windows CE
operating system and components, in
addition to Dynalite Touchscreen Panel
software.
Integrated
control
security, HVAC etc.
Objects (logos, buttons, faders, floor
plans, diagnostic icons etc) can be
placed on pages and used to perform
simple and complex conditional logic
macros.
Pages are created using
Dynalite‟s touchscreen editor.
Warning
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS DEVICE TO RAIN OR MOISTURE.
DO
NOT
ENERGISE
FRONT COVER IS IN PLACE.
INSTALLATION,
MAINTENANCE MUST BE CARRIED OUT
BY QUALIFIED PERSONNEL
2
DTP100 Instruction Manual Rev D.docx
of
lighting,
AV,
UNLESS
THE
PROGRAMMING
AND
important safeguards
Please read these instructions
Special programming – This device will only
operate in basic modes until programmed. If
programming is required, contact your local
agent for details. Once the data cable is
connected to the device, the factory default
settings will allow the panel to control all
channels in all dimmers.
Mounting location – This device must be
mounted indoors away from direct sunlight.
The optimum viewing angle is 75°. Ensure that
the LCD display will be at or slightly below eye
level for all users. Take this into account when
deciding the mounting location.
Data cable – The recommended cable for
connections to the serial port is screened,
stranded RS485 data cable with three twisted
pairs. Part numbers for various manufacturers
are listed on page 5. This cable should be
segregated from mains cables by a minimum
distance of 300mm. If anticipated cable runs
are over 600 metres for serial cables or 12
metres for analogue cables, consult your
Dynalite dealer for advice. Do not cut or
terminate live data cables.
The display – The DTP100 LCD display and
touch membrane are very sensitive to damage
from sharp or hard objects. Never operate the
panel using anything other than your fingertip.
The miniature fluorescent tube backlight is very
fragile and runs at a high voltage. Ensure there
are no protrusions when fitting the panel to the
wall. If cleaning is required, use a dry cloth or
soft cloth with alcohol, neutral detergent or
ethanol for clearing of dirt and smudging.
Power supply – The DTP100 Touchscreen
Panel is powered from the DyNet network and
does not require mains voltage supply.
Advertisement
