Connecting The Usb Nano Receiver - Silvercrest DMTS2017 User Manual

English

Connecting the USB Nano Receiver

Remove the USB nano receiver from its storage
compartment (see
Batteries").
Plug the USB nano receiver into a free USB port on
your powered-on computer.
The operating system will automatically recognize the new hardware and install
the required drivers. Depending on the operating system installed, the following
screen messages may appear:
®
Windows 2000/XP
When the receiver is connected for the first time, the operating system
®
Windows 2000/XP displays the message „New hardware detected". Wait until
the message „The new hardware has been installed and is now ready for use" is
displayed before using your mouse and keyboard.
®
Windows Vista , Windows
When the receiver is connected for the first time, the operating system Windows
Vista™ displays the message „Installation of appliance driver software". Wait
until the message „The appliances are ready for use now" appears. The mouse
and keyboard are now operational and ready to be used.
If your previous mouse and keyboard are still connected to the computer, please
shut down the computer, disconnect the appliances in question and then restart
the computer.
Should the wireless mouse fail to work, power it off and back
on. Sometimes removing and re-inserting the batteries will also
help.
12
Wireless keyboard with wireless mouse DMTS2017
the chapter "Inserting
®
7
the
Fig.: Miniature USB Receiver