Interface Implementation; Set The Switch Interface Type - Toshiba Strata DK Interface Manual

Interface Implementation

Set the Switch Interface Type

PN: 1725-36145-001_D.doc
This section describes the recommended programming to use the
Wireless Telephone System with a Toshiba Strata DK/CTX key
telephone system. The procedures assume:
• The Toshiba system is installed and operational in an approved
configuration. See the Telephone Switch Interface Matrix
document for tested configurations.
• A trained Toshiba Strata technician or system administrator will
be on site with the Installer to program the system.
• The SpectraLink 6000 System or SpectraLink 8000 Telephony
Gateway is installed and the handsets are available for
programming.
SpectraLink 6100 MCU
The SpectraLink 6100 Master Control Unit requires the switch
interface type to be configured using the front panel buttons. The
configuration procedures are detailed in SpectraLink 6100 MCU:
Installation and Operation.
SpectraLink 6300 MCU
When configuring the SpectraLink 6300 MCU, the PBX interfaces are
available as sub-menu selections when defining the Interface Module
type using the SpectraLink 6300 MCU Operator's Console. Refer to
SpectraLink 6300 MCU: Operator's Console for details on configuring
the Interface Modules.
SpectraLink 8000 Telephony Gateways
Connect to the SpectraLink 8000 Telephony Gateway using the serial
or modem interface. From the Main Menu, choose Gateway
2
13