Memory - Medisana BU 550 Connect Instruction Manual

The blood pressure indicator
on the WHO blood pressure classification. If the unit has detected an irregular heart-
beat, the arrhythmia display
7.
The readings are automatically saved in the selected memory (
a guest mode measuement has been finished (see chapter 3.4 Setting up the user
memory). Up to 500 measured values with date and time can be stored in each me-
mory.
8.
The measurement results will automatically be transferred via Bluetooth to receive-
ready devices. During this process, the Bluetooth-symbol
was successful, the Bluetooth-symbol
play. If the transfer was not successful, "Err" will appear.
9.
The unit switches off automatically after approx. 1 minute if no buttons are pressed.
The unit may also be switched off using the START/STOP button
4.3 Transfer via Bluetooth to VitaDock online resp. VitaDock app
The MEDISANA Upper arm blood measurement monitor BU 550 connect offers
the possibility to transfer your measured values via Bluetooth to the VitaDock online
portal resp. to the VitaDock app. These VitaDock applications allow the evaluation,
storage and synchronisation of your data between multiple iOS- and Android-devices
to have access to it anytime and anywhere. You may share your results with your
friends or your doctor. Therefore you need a free user account, which you can create
on the website www.vitadock.com. For Android or iOS mobile devices, you may down-
load the respective apps. You will find a detailed instruction for how to install and use
the software on the mentioned website. After each blood pressure measurement an
automatic transfer will be initiated by the device - Bluetooth therefore should be acti-
vated and configured on the receiving device(s). If you want to transfer the stored
values from your BU 550 connect manually, please follow these steps:
Press and hold START/STOP-button
1.
transfer mode.
The Bluetooth-symbol
2.
If the transfer was successful, the Bluetooth-symbol
3.
"OK" in the display. If the transfer was not successful, "Err" will appear.

5 Memory

5.1 Displaying stored results
You can store up to 500 readings (blood pressure and pulse rate with the time and
date) in either one of the memories (U1 and U2) in your blood pressure monitor.
The measured values are stored automatically. Press the M-button
measured values stored. The average values of the last 3 measurements of the res-
pective user appear on the display. Press the M-button
from the previously stored measurement. Repeatedly pressing the M-button
plays the respective values measured previously. Press the S-button
the more actual stored results. The unit switches off automatically after approx. one
minute if no buttons are pressed. The memory recall mode may be exited at any time
by pressing the START/STOP button
ed values have been stored in the memory and a new value is saved.

flashes next to the relevant coloured bar depending

appears additionally.

®


flashes and the transfer begins.

. The oldest value is deleted if 500 measur-
4 Operating / 5 Memory

will flash. If the transfer
will appear together with "OK" in the dis-
®
®
for 3 seconds, to enter the manual

will appear together with

again to display the values
GB
i
or ), except if
i
i

.
®
®
i
i

to call up the

dis-

to browse to
25