Ipv6 Firewall - D-Link AC750 User Manual

Section 3 - Configuration
The DIR-818LW's IPv6 Firewall feature allows you to configure which kind of IPv6 traffic is allowed to pass through the device.
The IPv6 Firewall functions in a similar way to the IP Filters feature.
Enable IPv6 Check the box to Enable the IPv6 firewall simple security.
Simple Security:
From the drop-down menu, select Turn IPv6 Filtering OFF, Turn
Configure IPv6
Filtering below: IPv6 Filtering ON and Allow rules listed, or Turn IPv6 Filtering
ON and Deny rules listed.
Enter a Name to identify the IPv6 firewall rule.
Name:
The schedule may be set to Always, allowing this service to always
Schedule:
be enabled. Or select a schedule from the drop-down menu for
enabling the IPv6 Firewall Rule. You can create your own schedule
in the Tools > Schedules section.
Source: Use the Interface drop-down menu to specify the interface that
connects to the source IPv6 addresses of the firewall rule.
Enter the source IPv6 address range in the adjacent IP Address
IP Address Range:
Range field.
Select the protocol of the firewall port (All, TCP, UDP, or ICMP).
Protocol:
Dest: Use the Interface drop-down menu to specify the interface that
connects to the destination IP addresses of the firewall rule.
Enter the destination IPv6 address range in the adjacent IP Address
IP Address Range:
Range field.
Port Range: Enter the first port of the range that will be used for the firewall rule
in the first box and enter the last port in the range in the second box.
Click Save Settings.
D-Link DIR-818LW User Manual

IPv6 Firewall

92