Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 416

HEATER, AIR CONDITIONER AND VENTILATION
Rotor
Snap ring
Tapered part
Thickness
gauge
120°C
Continuity
No continuity
"BA SNAP RING INSTALLATION
Field core
Using snap ring pliers, fit the snap ring so that the snap
ring's tapered part is on the outside.
"CA SELF-LOCKING NUT INSTALLATION
Using a special tool, as when removing the nut, secure the
armature and tighten the self-locking nut.
"DA AIR GAP ADJUSTMENT
Apply voltage from the battery to the magnetic clutch and
check that the clutch air gap is inside the type. value.
If outside the type. value, use a shim to adjust the gap.
Standard value: 0.3 – 0.5 mm
NOTE
The shims are available in 0.05 mm steps across the thickness
range 0.35 - 0.70 mm, and in 0.1 mm steps of thickness.
INSPECTION
Cooling temperature switch
1. Dip the metal part of the cooling temperature switch into
Thermometer
2. When the oil temperature reaches the type. value, check
Engine oil
150°C
Oil temperature
-
Compressor
engine oil and increase the oil temperature using a gas
burner or similar.
Caution
Do not heat more than necessary.
that voltage is supplied between the terminals.
Standard value:
Item Temperature
Continuity Slightly below 150°C
No continuity 150°C or higher
(until temperature falls to 120°C when OFF)
55-39