ABB HTP500 User Manual page 14


If the printer begins working not properly, emitting smoke or strange smells, turn it off
immediately, unplug the power cord and contact the ABB™ Technical Assistance

Never handle the power cord with wet hands

Don't use multi socket adapters to plug more than one device into one single plug

Make sure that the power cord is properly plugged in

Don't put the power cord close to a heat source for to not to melt it

Never attempt to disassemble or modify the printer

Before cleaning the printer, always turn it off and unplug the power cord

When cleaning the printer, dampen some gauze and wring it out thoroughly. Don't use
flammable solvents, such as alcohol, benzene or paint thinner.

Don't connect the printer to a power source that provides other than the rated voltage: 100÷240
V AC, 50/60Hz

If some foreign material (a piece of metal, some water or some other liquid) gets inside the
printer, turn the power off immediately, unplug the power cord and contact the ABB™ Technical
Assistance

While unplugging the power cord, always grasp the plug, not the cord. Pulling the cord could
damage it

If the printer is not going to be used for a long time, unplug the power cord. If the cord is not
unplugged, that could result in an electrical leak.

It is always a good habit not to leave the cord plugged in for long periods of time anyway.
1.3.3 External Cleaning of the Printer
Always clean the printer when it is turned off and not plugged to Power. Use a dry fabric or a
little wet tissue with water. Do not use flammable liquids.
1.3.4 Use and Maintenance
Failure to follow the warnings and cautions described below during use and maintenance of
the printer could result in accidents, fire, electrical shock or burns.

Don't touch the print head immediately after printing

Don't use this printer and its accessories for any purpose other than the one designed for

Use only the ribbon cassette on equipment. Never attempt to disassemble the ribbon cassette
to place another ribbon inside the cassette

Don't pull the plate or sheet while print is being in progress

Don't expose HTP500 V2 to direct sunlight, high humidity or dust. Use and store the printer
and its accessories respecting the environmental conditions listed below:
1.3.5 Precaution while moving the Printer
Before moving the printer while using and maintaining the HTP500 V2, always observe the
precaution here following to prevent risks of fire, electric shock or burns.
 Remember that the printer weight is 9,5 kg
 Lift up the printer with both hands
 Keep the printer near the person body while you are moving it
WARNING
CAUTION
WARNING
CAUTION