EN | 2 General Information Mounting the Point Transmitter The SE3401 Point Transmitter is a magnetic and dry Avoid mounting the point transmitter on contact wireless transmitter used for monitoring assets. metal surfaces as it can reduce the range of The unit is equipped with an internal reed contact for the unit.
Figure 4: Mount Transmitter Using Tamper Screw of the case as the reed switch. Figure 6: Mount Point Transmitter in Desired Location 1 - Tamper screw 1 - Magnet side 2 - Mounting holes Bosch Security Systems | 6/03 | 40281E...
DL123A, Energizer EL123AP, or Panasonic CR123A. unit. Be sure to observe the polarity. Figure 7: Mount the Magnet Figure 8: Install Battery 1 - Battery 1 - End view from the opening end Bosch Security Systems | 6/03 | 40281E...
EN | 5 Setting Up Magnetic or Figure 11: Magnet (Optional) Typical NO Wiring External Contacts The SE3401 has the capacity to monitor magnetic and/or dry external contacts. External Normally Closed (NC) or external Normally Open (NO) contacts can be monitored.
This device must accept any interference received, including interference that can cause Figure 1: ID Sticker undesirable operation. Changes or modifications not expressly approved by Bosch Security Systems can void the user’s authority to operate the equipment. 167770187 167770187 1 - ID number...
Page 7
SE3401 | Installation Instructions | Notes: EN | 7 Notes: Bosch Security Systems | 6/03 | 40281E...