Sub Bright Adjustment; Screen Center Adjustment; Favorites Adjustment - Sony KF-60DX100 Service Manual

4. Adjust the blue in the same manner.
Category
D-GM TPN 8
LCD-DR 12
LCD-DR 13
*: Fundamentally, this item is adjusted with the EVEN VR only, but if
the adjustment range is not enough, the ODD VR may also be
adjusted.
5. Write the data by pressing the [MUTE] + [ENTER] buttons on
the remote commander.

3-4. SUB BRIGHT ADJUSTMENT

1. Enter the monoscope signal to the VIDEO 5 input, and set
the PICTURE MODE to "Vivid" and the WIDE MODE to
"Full".
2. Adjust the SUB BRT so that the borderline of 0IRE and
10IRE becomes distinctive.
Adjustment positions
Category Item
D-GM IM 2 SUB CON
D-GM IM 3 SUB BRT
*: If the adjustment is imperfect though the SUB BRT value is 0, lower
the SUB CON value and make further adjustment.
Note: If the SUB BRT value exceeds 32, make sure that there is no noisy
black of 0IRE.
Though the SUB CON value is generally lowered only, if it is to be
raised, take care not to cause the white blurring.
3. If the SUB CON value was changed, check the white balance
and repeat adjustment to attain best sub brightness, sub
contrast, and white balance.
4. After the adjustment finished, write the data by pressing the
[MUTE] + [ENTER] buttons on the remote commander.
Item Data
T-PATN RGB 4 (B)
B ODD VR ADJ*
B EVEN VR ADJ
Standard value
25*
20

3-5. SCREEN CENTER ADJUSTMENT

1. Enter the RF monoscope signal.
2. Adjust so that the picture is displayed in the center of the
screen.
Adjustment position
Category
HV POS AD
3. Make sure that a difference in horizontal graduations is
below 0.1 frame, and a difference in vertical graduations is
below 0.1 frame, and then write the data by pressing the
[MUTE] + [ENTER] buttons on the remote commander.

3-6. FAVORITES ADJUSTMENT

1. Enter the RF signal, and press the [FAVORITES] button on
the remote commander.
2. Adjust so that the "Favorites" displayed on the right side of
the screen comes to the center of the display area.
Adjustment position
Category
OSD
Main Screen
"Favorites" OSD area
3. After the adjustment finished, write the data by pressing the
[MUTE] + [ENTER] buttons on the remote commander.
– 43 –
KF-60DX100
Item
0 H POS ADJ
1 V POS ADJ
Item
1 HPOF
Sub Screen
Favorites
2
3
4
5
RM-Y910