JVC HM-HDS1EU Instructions Manual page 93

OTHER PROBLEMS
SYMPTOM
1. Whistling or howling is heard from
the TV during camcorder
recording.
2. When scanning channels, some of
them are skipped over.
3. The channel cannot be changed.
4. Channel settings that were made
manually seem to have changed or
disappeared.
5. No channels are stored in the
recorder's memory.
6. The remote control won't operate
the TV or satellite receiver.
ATTENTION
This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch
the recorder off and unplug the mains power cord. Then plug it in again and turn the recorder on. Take out the cassette. After
checking the cassette, operate the unit as usual.
POSSIBLE CAUSE
The camcorder's microphone is too
close to the TV.
The TV's volume is too high.
Those channels have been
designated to be skipped.
Recording is in progress.
After the manual settings were
made, Auto Channel Set was
performed.
The TV aerial cable was not
connected to the recorder when
Auto Set Up was performed.
The fully-wired 21-pin SCART cable
was not connected between TV and
the recorder when Preset
Download was performed.
The remote control brand setting is
incorrect.
CORRECTIVE ACTION
Position the camcorder so its
microphone is away from the TV.
Turn the TV's volume down.
If you need the skipped channels,
restore them ( pg. 82).
Press to pause the recording,
9
change channels, then press
resume recording.
Perform manual setting again.
Turn off the recorder once and
connect the TV aerial cable to the
recorder properly, then turn on the
recorder again. The recorder will try
Auto Set Up again ( pg. 14).
Turn off the recorder once and
connect the fully-wired 21-pin
SCART cable to the recorder properly,
then turn on the recorder again. Then
perform Preset Download again
( pg. 16).
Re-set the remote control to the
correct brand. ( pg. 49, 50)
93
EN
to
4