Replacing the drum light socket:
1. Disconnect the dryer from electrical supply.
2. Raise the top and disconnect the wires from the
light socket.
3. Remove the light bulb, squeeze the tabs on the
side of the socket and push the socket into the
housing.
Replacing the felt seal:
1. Disconnect the dryer from electrical supply.
2. Remove the front panel.
3. The felt seal is a two piece seal that is glued to front
panel rim that the drum rides on.
4. To replace the seal pull the seal off and glue the
replacement to the rim.
Replacing the foam seal:
1. Disconnect the dryer from electrical supply.
2. Remove the front panel.
3. The foam seal is glued to front panel duct and seals
between the front panel duct and the blower.
4. To replace the seal pull the seal off and glue the
replacement to the duct.
Removing the rear access panel:
1. Remove the two screws holding the access panel
to the rear panel and swing the left side of the vent
out to disengage the tabs.
71