Removing The Connector Cover; Using The Clip-On-Type 3D Glasses (Bkm-31G) - Sony LMD-2451MT Instructions For Use Manual

Removing the
Connector Cover
When the unit is shipped from the factory, a connector
cover is attached to the PARALLEL REMOTE
connector and the SERIAL REMOTE connector (RJ-
45).
To use the connector, remove the connector cover as
follows.
Before removing the connector cover, disconnect the
power cord.
Connector cover
1
Remove the screw of the connector cover.
2
Remove the connector cover.
Save the screw and cover, so that you can reattach the
cover if necessary.
Caution
These connectors are designed to allow direct contact
with conductive circuits. Weak voltage may be present
because of a failure in this unit. To prevent patients from
touching these connectors accidentally, attach the
connector covers when the connectors are not being
used to connect to other devices.
22
Removing the Connector Cover / Using the Clip-on-Type 3D Glasses (BKM-31G)
Using the Clip-on-Type
3D Glasses (BKM-31G)
Clip the clip-on-type 3D glasses (BKM-31G) to the top
part of the frames of your eyeglasses.
The glass lenses can be flipped up when 3D effect is not
required.